Before Each Start-Up; How To Start - Craftsman 919.167320 El Manual Del Propietario

Ocultar thumbs Ver también para 919.167320:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

5.
Run the compressor for 15
minutes. Make sure the drain
valve is open and there is minimal
air pressure build-up in tank.
6.
After 15 minutes, close the drain
valve by turning clockwise. The
air receiver will fill to "cut-out"
pressure and the motor will stop.
The compressor is now ready for use.

Before Each Start-Up:

1.
Place On/Auto/Off lever to "Off".
2.
Pull the regulator knob out and
turn counterclockwise to set the
outlet pressure to zero.
3.
Attach hose and accessories.
NOTE: The hose or accessory
will require a quick connect plug
if the air outlet is equipped with a
quick connect socket.
pressure causes a hazardous
risk of bursting. Check the
manufacturer's maximum pressure
rating for air tools and accessories.
The regulator outlet pressure
must never exceed the maximum
pressure rating.
A10819
Risk of Bursting.
Too much air

How to Start:

1.
Turn the On/Auto/Off lever
to "On/Auto" and allow tank
pressure to build. Motor will
stop when tank pressure reaches
"cut-out" pressure.
2.
Pull the regulator knob out
and turn clockwise to increase
pressure. When the desired
pressure is reached push knob in
to lock in place.
The compressor is ready for use.
14- ENG

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido