GE GTE21GTHDWW Uso Y Cuidado Rápido página 28

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

REVERSING THE DOOR SWING
TO RE-HANG THE DOORS
1. Remove the hinge pin from the lower hinge bracket.
2. Remove the lower hinge bracket.
3. Install bottom hinge bracket on the opposite side of the
opening.
4. Install the lower hinge pin into the hinge bracket hole to the
outside of the refrigerator.
5. Position the fresh food door, tilted forward, over the lower
hinge pin and slide it into place.
6. While holding the door securely, align the socket in the door
with the hole in the center hinge. Attach the center hinge
and gasket with two screws.
7. Insert the hinge pin into the center hinge and tighten with a
Phillips screwdriver until the shoulder of the hinge pin is touch-
ing the center hinge.
Installation Instructions
(Cont.)
4
8. Place the freezer door on top of the center hinge pin.
9. With the freezer door in place, place the left top hinge so
the pin fits into the door socket. The left top hinge and
cover can be found inside the product. Call GE Service at 800.
GE.CARES (800.432.2737 or in Canada call 800.561.3344 if parts
are missing.)
10. Support the door on the handle side and make sure the door
is straight and the gap between the doors is even across the
front. While holding the door in place, tighten the top hinge
screws. Do not overtighten these screws. Tighten them until
they are just snug, and then turn them another one-half turn.
11.Snap the left top hinge cover over the hinge.

Publicidad

Tabla de contenido
loading

Tabla de contenido