Chauvet DJ 4BRATri USB Guía De Referencia Rápida página 5

4BAR™ Tri USB QRG
DMX Linking
Starting
Address
Master/Slave
Connection
Infrared Remote
Control
D-Fi™ USB
Connectivity
The 4BAR™ Tri USB can work with a DMX controller when linked by DMX serial
connections. Instructions for DMX operation are in the User Manual. A DMX Primer is
available from www.chauvetlighting.com
To ensure full access to all channels in each DMX mode, the highest recommended
DMX address is 498.
The 4BAR™ Tri USB uses the DMX data connection for its Master/Slave mode.
Instructions for connecting and configuring this product for Master/Slave operation are
in the User Manual.
The 4BAR™ Tri USB is fully compatible with the Infrared Remote Control (IRC-6)
from CHAUVET® DJ For more information on the IRC-6 or to download instructions,
go to www.chauvetlighting.com.
The 4Bar™ Tri USB is able to become a D-Fi™ wireless receiver/transmitter with the
use of the D-Fi™ USB from CHAUVET® DJ. Simply set the DIP switch D-Fi™
receiving/transmitting channel, plug it into the USB port then set the product's DMX
Personality and DMX Address. Further instructions for connecting and configuring this
product for D-Fi™ USB operation are in the User Manual.
WARNING! DO NOT plug anything other than a D-Fi™ USB into the USB port.
Doing so may cause damage to the product.
Once plugged in, the D-Fi™ USB will take over the product. Wired DMX, manual
display control/menu buttons and IRC-6 will be unavailable until you unplug the
D-Fi™ USB. The priority levels are:
1. D-Fi™ USB
2. Wired DMX
3. IRC-6 Remote Control
4. Manual Digital Display/Menu Buttons
.
5
EN