NORTH STATES 8748 Manual De Instrucciones página 4

Step 6
Insert the locking clip into place. Note: The locking clip is very
hard to remove and once installed determines the top of the gate
from the bottom. The locking clip is always on top. See Figure 6.
Operating the Gate
To operate the gate, simply slide it
closed until the locking end of the
gate has reached the locking rail.
Align the gate end with the locking
rail (Figure 8) and lift up slightly on
the gate, allowing the docking pegs
to fit into the locking rail top and
bottom openings. Press the gate
end into place. You may hear a
slight click as the locking clip
engages the locking rail (Figure 9).
NOTE: Make sure both top and
bottom docking pegs are engaged.
You should not be able to lift up the
gate's locked end if it is engaged
correctly with the locking rail.
To unlock the gate, push down
with your thumb on the locking clip,
and pull up on the gate panel
(Figure 10).
Removal of the Gate
To remove the gate from the wall hinge, press in on the upper
locking boss located on the wall hinge (see Figure 11), and lifts up
on the gate itself, until the gate rib clears the locking boss. Then
press in on the lower boss and lift your gate off the wall hinge.
Cleaning Your Gate
Rinse with clear water and wipe dry with a soft cloth.
NOTE: Never use solvents, chemicals, scouring powders or sharp tools
when cleaning the gate.
FIGURE 8
Docking
Pegs
Page 4
FIGURE 6
FIGURE 9
FIGURE 10
FIGURE 11
Upper
Locking
Boss
Lower
Locking
Boss