Brita RF-103 Instrucciones De Instalación página 6

Attach inbound
water line to filter
• Turn on the water supply and flush
the filter into a container for ten
minutes.
• This flush will remove the air from
the filter and the small carbon
particles. During the flushing
process, the water will turn dark in
color. Continue flushing the new
filter until the water runs clear.
• Turn off the water supply.
• Warning: DO NOT screw system head
directly to refrigerator.
• Water supply to the refrigerator should
have a separate shut off valve installed
before the filter.
Install filter and test
for leaks
• Install the appliance side of the water line into the fitting.
• Follow the same procedure as used for the supply side of the filter.
• Turn on the water supply.
• Check for leaks.
Note: If leaks continue, turn off the water supply and call Customer Service or your local plumber.
6
Step 2
materials and tools needed
bucket
Step 3
WARNING
<< Step continued from previous page
WARNING
Supply line to
Refrigerator Source