3.8 Partition for Paper Roll
Set the partition to the width of the paper roll you are loading.
The partition is set at the factory to the position shown below.
For 3-inch type: 80-mm wide paper roll
For 2-inch type: 58-mm wide paper roll, 60-mm wide paper roll
1.
Turn off the power.
2.
Press up on the cover open butto n to open the paper cover.
3.
Press in the position shown by the arrow and set the partition in a slot that matches
the width of the paper roll you are using. However, to use an 83-mm wide paper roll,
remove the partition. Or, when you are using a 60-mm wide paper roll with the 2-
inch type, remov e the partitio n installed for 58-mm.
4.
Refer to "5.3 Manu al Setting of Memory Switches" to change the paper width
settings.
CAUTION
Make sure the partition is not slanted when setting it for 58-mm or 60-mm paper rolls.
Calle Llanos de Jerez 18 Nave 9 Coslada https://v10consumibles.com Tel: 910 269 309
(2-sheet partition installed.)
*1
— 33 —
V10 CONSUMIBLES S.L.
Partition
*1
*2
Notes:
*1: 2-inch type (58/60 mm)
*2: 3-inch type (80/83 mm)