Adjusting The Paper Near-End Sensor - Citizen CT-S651II Manual De Usuario

3.1 0

Adjusting the Paper Near-end Sensor

Change the settings of the paper near-end sensor to set the position at which
the near-end of the paper is detected.
1. Use a pointed object, such as a pen, to gently press the button to change the pap er
near-end sensor.
2. Press and hold down the button while mo ving the paper near-end sensor up and
down. The sensor positio ns are shown belo w for the variou s diameters of the pap er
roll used.
Senso r positi on
A
B
*
C
Note:
*: Position of sensor when shipped from factory. However, factory settings differ depending on the
destination market.
CAUTION
The diameter of the roll of paper that is detected is an estimate. Some variations may
occur depending on the paper.
Button to change paper
near-end sensor
Calle Llanos de Jerez 18 Nave 9 Coslada https://v10consumibles.com Tel: 910 269 309
Exterior diameter when detected as
near end
Approximately 31
Approximately 23
Paper near-end sensor function is off
V10 CONSUMIBLES S.L.
Exterior/ interior diame ter of core of
— 35 —
(Unit: mm)
paper roll used
18/12
18/12