Relative Measuring Mode (Setting Zero Point); Storage Of Values In Memory Module; Storage Of Values In Internal Memory - Nedo mEsstronic 583111 Manual De Instrucciones

3 Operation

3.4 Relative measuring mode (setting zero point)

Change to the relative measuring mode by pressing the
ment is then set to zero. All the following measured values then refer to this zero point! The
measured values are shown in the display with the correct sign. The reference measurement
can be displayed by pressing the
ess. The relative measuring mode can be left by pressing the
measured values (absolute measurement) are displayed. Before setting a new zero point, se-
lect the absolute measuring mode.
3.5 Storage of values in memory module [Ref.-No. 585115]
The memory module allows 511 measured values to be stored in memory
spaces 000 to 510.
Note: Insert and pull out the memory module only when the mEsstronic is switched off.
Note: Never plug a memory module into a mEsstronic without batteries or when batteries
Pressing the MEMORY
space is automatically incremented by one, and the display shows the stored measured
value and the letter "M". The measuring process is continued by pressing the
extending or retracting the telescopic elements by more than 7 mm. Please refer to chapter
3.7 regarding the recall of the stored data. New memory modules or those which have been
used in other Nedo devices must be formatted for use with the mEsstronic; otherwise an er-
ror message [Err.3] is displayed. The memory module is formatted by pressing the
first and, keeping it pressed, activating the
the entire memory.

3.6 Storage of values in internal memory

The internal memory allows to store 10 measured values in the memory
spaces 000 to 009. In order to store a measured value and then to reinitialise
the instrument further measurements, the MEMORY,
be pressed one after the other. This applies when no memory module has been inserted.
mEsstronic 1.0 Operating Instructions
ZERO key once more during the relative measuring proc-
are flat!
key stores the currently displayed measured data value. The memory
UP
ZERO key. The current measure-
ON key and then the true
and DOWN keys simultaneously. This clears
ON key or by
ON key
UP and ON keys must
EN
14