Accessories; Measuring Jaws; Rs 232-Module; Bluetooth Module Blueconnect - Nedo mEsstronic 583111 Manual De Instrucciones

4 Accessories

4.1 Measuring jaws [Ref.-No. 583500]
In order to attach the measuring jaws, the innermost telescopic tube must be extended by
approx. 100 mm. Move the measuring jaw with the large clip is over the outer tube of the
mEsstronic. When the small plastic stud of the measuring jaw rests in the first/second notch
of the display housing, measurements can be carried out with/without measuring spikes. Now
move the measuring jaw with the small clip over the narrow side of the small tube and snap it
onto the tube. When taking measurements with spikes fix them onto the measuring jaws, re-
tract the mEsstronic and screw the two locking screws tight.
Note: Before taking measurements, set the mEsstronic to zero by pressing the ZERO key
when retracted. Otherwise, there is a danger of incorrect measurements being taken.
4.2 RS 232-module [Ref.-No. 585226]
The RS 232-module is inserted like the memory module into the display
housing. This module must also be inserted and pulled out when the device
is switched off. After connecting the module to a target device and switching
on the mEsstronic as well as the target device, the currently displayed measured values are
transferred by pressing the
mEsstronic is switched off for a short time in order to provide the operator with a visual sig-
nal. Note: The data transfer may be disturbed by electrostatic discharge in unfavourable con-
ditions. The target device must be set to following transfer parameters: 2400 baud, 1 start bit,
7 data bits, 2 stop bits, no parity.
4.3 Bluetooth module BlueConnect [Ref.-No. 585228]
BlueConnect uses a mEsstronic for wireless transfer of specific inside dimensions to a PC,
pocket PC or a machine control. The Bluetooth
values from the following Nedo products:
mEsstronic Ref.-No. 58x111 (resolution 1.0 mm)
mEsstronic Ref.-No. 583115 (resolution 0.1 mm)
BlueConnect cannot be used with mEsstronic Easy Ref.-No. 58x121.
mEsstronic 1.0 Operating Instructions
MEMORY key. At the beginning of the transfer, the display of the
®
BlueConnect module can transfer measured
EN
16