Mounting The Pendant - Velleman Vellight LEDAD1NW Manual Del Usuario

Lampara de techo-redonda-color blanco neutro
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 12
Use the original packaging if the device is to be transported.
Keep this manual for future reference.
4.
Features
LED pendant light series
ultra-thin design concept
5.
Overview
Refer to the illustrations on page 2 of this manual.
base plate
1
suspension wires
2
ring
3
lamp
4
6.

Mounting the Pendant

Warning! This luminaire does not have a built-in device to disconnect it from the electric mains. Make
sure to electrically isolate the luminaire before installation or maintenance activities are performed.
Make sure that you do not damage any wiring during installation.
To hang the pendant from the ceiling, proceed as follows:
1. Check if the ceiling is sturdy enough to carry the weight of the pendant.
2. Provide suitable cabling from the mains to the pendant.
Warning! Provide a secure connection. The mains circuit must be earthed and protected with a suitable
fuse.
3. Use the ceiling plate [7] to mark the exact location of the screw holes on the ceiling, and drill the holes.
4. Caution: Check if the plugs and screws are suitable for your mounting location. Make sure to obtain the
required hardware. If in doubt, consult a professional.
5. Insert appropriate plugs [6]. Pull the mains cable through the centre hole in the ceiling plate, and use
appropriate screws [8] to fix the ceiling plate to the ceiling [A].
6. Adjust the length of the suspension wires [2] as follows: on each suspension wire, push the clamp [5] on
the wire holder to release the wire and pull the wire out to the desired length.
7. Roll up the excess length of wire. Use cable ties to hold the wire together if necessary. Make sure that the
wire fits in the base plate [1] without damaging the other components and connections.
Caution: be very careful if you want to cut off the excess length of suspension wire. The
suspension wire with the plastic coating contains the supply to the LEDs. If you cut off the coated wire, you
cut off the supply and the pendant will not work. Damage caused by careless installation is not covered by
the warranty.
8. If necessary, you can adjust the position of the ring [3] as follows: loosen the three screws in the ring
using a hex key, and move the ring to the desired position. Tighten the screws again.
9. Open the white plastic junction box [9] in the base plate and connect the mains cable to the screw
connectors inside the box [B]. Make sure the connection is properly earthed. Make sure there is no strain
on the cables; leave sufficient slack.
N = neutral, blue
E = earth, yellow/green
L = line, brown
Warning! If the power cable is damaged, it must be replaced by the manufacturer, his
service agent, or a similar qualified person in order to avoid any hazard.
10. Close the junction box carefully without damaging any wiring.
11. Slide the notches in the base plate over the screws on the outside of the ceiling plate and turn the base
plate to the right to hook it over the screws [C].
12. Before you tighten the screws, check if the pendant is level. If not, adjust the length of the suspension
wires or adjust the position of the ring.
13. When the pendant is level, tighten the screws on the outside of the ceiling plate to fix the base plate.
The pendant is now ready for use. It lights up when switched on.
V. 01 – 18/04/2014
LEDAD1NW
housing: aluminium
housing colour: white.
clamp
5
plugs
6
ceiling plate
7
screws
8
4
junction box
9
10 screw
11 notch
©Velleman nv

Publicidad

Tabla de contenido
loading

Tabla de contenido