Mounting The Device; Fuse Replacement - Velleman VDPLW1308BI Manual Del Usuario

g. DMX Modes
DMX mode 1: 48-channel operation (control each VDPLW1308BI independently).
DMX mode 2: 24-channel operation (control 4 sets of 2 VDPLW1308BIs).
DMX mode 4: 12-channel operation (control 2 sets of 4 VDPLW1308BIs).
DMX mode 8: 6-channel operation (control all 8 VDPLW1308BIs).
h. Mounting the Device
• Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable norms.
• The carrying construction must be able to support 10 times the weight of the device for 1 hour without deforming.
• Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified technician
check the device once a year and once before you bring it into service.
• Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
• Overhead mounting requires extensive experience: calculating workload limits, determining the installation
material to be used... Have the material and the device itself checked regularly. Do not attempt to install the
device yourself if you lack these qualifications as improper installation may result in injuries.
• Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
• Make sure there is no flammable material within a 0.5m radius of the device.
• Have a qualified electrician carry out the electric connection.
• Connect the device to the mains with the power plug. Do not connect it to a dimming pack.
• The installation has to be approved by an expert before the device is taken into service.
i. Fuse Replacement
The fuse of your VDPLW1308BI may be replaced as illustrated.
Caution: Always replace the fuse with a fuse of the same type and
rating. Disconnect from the mains before replacing.
VDPLW1308BI
5 VELLEMAN