Yakima ButtonDown AERO Manual De Instrucciones página 2

reMOVe BaSe SCreW
Use hex wrench.
FaCTOrY BarS— Use the correct bail screw.
• Some factory bars may require the long bail screws.
• Screws must extend below bail.
• if screws are too short, you must use the
LONG BaiL SCreWS.
WOrK ON a FLaT SUrFaCe
• Open carrier
• Press button with thumb to open.
aTTaCH UPPer BaiL TO
SLiDer TOP
• Align the base screw with
square nut (inside upper bail.)
• Use hex wrench to engage the
screw and nut.
• Do not tighten yet.
1033380C-2/15
reMOVe ONe BaiL SCreW
• Use hex wrench.
• Loosen the
remaining screw,
but leave it in place.
In some cases, the bails
(BaiL
may not be parallel.
SCreWS
TOO SHOrT)
• Insert base screw
through hole in pad.
• Position slider top
onto screw.
SLiDe BaiLS TO eXPOSe
SCreW HOLeS
OK
aSSeMBLe