Yakima ButtonDown AERO Manual De Instrucciones página 4

SeCUre MOUNTiNG aSSeMBLY
• Slide carrier to expose
screw holes.
• Use hex wrench to
tighten screws.
TiGHTeN CarrierS TO MOUNTiNG HarDWare
LOaD SKiS Or
SNOWBOarDS
• Keep the tips toward the
rear of the vehicle.
• Load bindings between
the carriers.*
*In some cases you may need to
close the mount between your
bindings. Position them fore/aft to
best avoid hatch contact.
1033380C-4/15
Make sure carriers are
CLOSe CarrierS
WiTH FirM
PreSSUre
OPeN Carrier
vertically aligned.
VeriFY THe CLOSUre!
• Pull upward on upper section of
carrier to see if the carrier can open.
• if it opens, apply more pressure
when closing the carrier.
ON SOME BARS
the mounting hardware
may sit at an angle.