Publicidad
POWER FORWARD
The ALL NIGHT extends the power of your HERO™, HERO™3+ and HERO™ 4 models to
more than 5X the specified run-time of the standard battery alone supplied with
your GOPRO® while still offering the rugged, waterproof* performance your camera
requires.
1. Remove existing GOPRO® case back and travel cover from ALL NIGHT By opening
door and pulling straight down out of brackets. Do not remove pin from door.
2. Snap on ALL NIGHT.
3. Attach flat USB cable plug to camera's USB input port using specified mini-USB
outlet depending on camera type (see back diagram below). Attach opposite end of
flat cable to camera's mini-USB power input port and close case. Ensure cable is
not caught in door when closed.
4. Open side door, press ALL NIGHT power button. Shoot longer .
1.
2.
* This product is waterproof up to 40M. Test battery/case for leaks BEFORE placing GOPRO®
in the case before EVERY use and ensure side access door latch is fully engaged. Brunton
is NOT responsible for camera damage while using Brunton products.
POWER UP
Open ALL NIGHT side access door and press power button to supply power to camera.
Charging indicator LED on camera will light to the status of the battery, red or green.
Press again to power off ALL NIGHT.
The ALL NIGHT can charge your smartphone or other USB charged device while
powering your GOPRO® camera at the same time. It can also be used as a convenient,
portable, stand-alone power source so you never have to power down. When used as a
portable power bank, please make sure travel cover is snapped onto the ALL NIGHT.
To use, open Patented side access door and plug USB powered device into USB output
port.
When closing side door, ensure latch is engaged to create waterproof seal.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
To recharge the ALL NIGHT, connect micro-USB input cable to a running computer, USB
outlet, or a Brunton portable power device. A solid red light on the battery level LED
indicator indicates that the ALL NIGHT is charging.
BR-Manual-ALL-NIGHT 7.0.indd 2-3
3.
4.
1. USB Output
(Charge other devices)
2. Power Button
3. Micro-USB Input
(Charge ALL NIGHT)
2
SIDE DOOR:
BACK:
(3.)USB PLUG STORAGE
3
WHEN NOT IN USE
Light Color:
Power Level:
RED/OFF
>30% (Flashing—Needs charge)
GREEN
30–100%
(Solid light indicates ALL NIGHT is charging)
OPERATING THE INTEGRATED LIGHTING
SYSTEM
The ALL NIGHT has been carefully designed to allow the capture of video in a wide
variety of low light conditions. It has multiple light mode settings to allow the best
capture depending on different environmental conditions. Due to the added weight of
the ALL NIGHT, it is suggested that a phillips head screwdriver be used on the GOPRO®
mount tightening screw (See A Below).
TO TURN LIGHT ON/OFF: Press and hold power button for 2 seconds until light turns
on or off.
1. Light Power/Function Button
2. Mode Indicator Lights (On Back Of Metal Housing)
3. Metal Housing
TO CHANGE LIGHT MODE: Press button for 1 second or less. NOTE: When light is
turned off, it will turn on in last light mode setting so user does not have to cycle
through modes to select current mode.
USB Output
(Charge other devices)
Power Button
Micro-USB Input
(Charge ALL NIGHT)
USE (1.) USB OUTPUT FOR
HERO™ 3 AND 4 SERIES CAMERAS
1
2
USE (2.)USB OUTPUT
FOR HERO™ CAMERA
1
2
A
3
3
10/12/15 10:00 AM
Publicidad
