Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
7) Attach supply lines to 1/2" IPS inlet
connections on faucet body (H).
Using a wrench, finish with one half
turn. DO NOT overtighten.
Maintenance
1) Remove set screw (A). Turning
counterclockwise, disassemble
handle (C) and nut (D) from car-
tridge (E or F).
C
Finish is spotting.
Symmons Industries, Inc.
Copyright © 2016 Symmons Industries, Inc.
8) Attach supply lines to shut-off
valves and hand tighten. Using a
wrench, finish with one-half turn.
DO NOT overtighten.
1
H
2) Remove cartridge (E or F) from
faucet body (H). Inspect for
debris. Replace cartridge if
necessary.
A
D
E
F
Troubleshooting Chart
Elements in water supply may cause
water staining on finish.
■
■
31 Brooks Drive
■
www.symmons.com
1
2
E
F
H
■
Braintree, MA 02184
Phone: (800) 796-6667
■
gethelp@symmons.com
9) Remove aerator (G) and flush
lines free of debris. Check for
leaks.
3) Install cartridge and handle assembly
following steps 1 and 2 in reverse.
Clean finished trim area with a soft
cloth using mild soap and water or a
non-abrasive cleaner and then quickly
rinse with water.
■
Fax: (800) 961-9621
■
■
ZV-3116 REV C
022416
G
Publicidad
Tabla de contenido
