9. Selecting Forward – Brake – Backwards
"Training"/Forward – Brake "Racing Mode"
Flashing
frequency
Direction of
travel
GB
•
Press the SET button down until the blue LED lights up. Release the SET
button again.
•
The blue LED starts flashing. This shows that you are in the mode for
setting the direction of travel.
•
Press the SET button again briefly. This brings you to the next setting.
The blue LED flashes at the next highest speed.
•
By repeatedly pressing briefly on the SET button you can scroll through
the settings.
•
When you reach the required setting, hold down the SET button for
approx. 2 seconds; the setting is stored.
•
Once you have stored the setting, the status LEDs flash one after
the other to show that you are leaving the programming mode. The
controller is ready for operation again.
•
If you do not press the SET button for more than 10 seconds the
controller reverts to the last setting and is ready for use again.
34
1
only forwards
"Racing mode"
CARSON DRAGSTER Brushless Controller
2
Forwards and backwards
"Training journey"