jbc AP 1300 Manual Del Usuario página 5

Replacing the reel
The reel is pressed into the support arm,
where it is held in place.
To extract the reel, rest the shaft end on a
convenient surface and press down on the
reel until it gives in.
Before fitting a new reel, pull out the solder
remaining inside the solder direcfion tube.
The solder flux may cause clogging at the end
of the solder direction tube: clean when
necessary.
To fit the new reel, position it in such a way that the
solder wire runs off at the botton and insert it into
its hole checking that the wire becomes straight.
Pull the trigger intermitentely and feed it until the
solder feed system works by itself.
Always use solder wire from 0.8 to 1.0 mm in
diameter.
Solder reel holder
For production-line purposes we recommend
using our BE 5520 holder Ref. 0552300, which
allows for solder reels of sizes up to 2.5 kg to
be used.
Simply wrap a couple of turns of the solder wire
around an empty reel as shown.
0552300
Fume extractor accessory Ref. 0451204
Suction pump
and filter
JBC reserves the right to make technical changes without prior
notification.
4
ENGLISH
0451204