Fuse Replacement; Technical Service - Campbell Hausfeld RP3200 Instrucciones De Operación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Operating Instructions
Important Safety Instructions
(Continued)
Do not leave the
infl ator unattended
while the unit is running.
Never
exceed
the recommended pressure
for any infl atable object. Do
not over infl ate objects. Over
infl ation could cause property damage
and/or personal injury.
Always put the car
in park; set the
emergency brake; and chock the wheels
before using the infl ator or property
damage and/or personal injury could
occur.
The universal
adapter must
be locked to secure the infl ation
accessories. Use extreme caution when
using infl ation accessories.
Avoid long extended
Always use a
separate pressure gauge to check the
actual pressure in tires and in low
pressure infl atable objects.
Avoid long extended
Infl ator must cool
for 20 minutes after 20 minutes of
continuous oper-ation. The Infl ator is
not designed to operate continuously
for more than 20 minutes.
The work surface
Do not use infl ator
on high pressure tires used on large
trucks, trailers or tractors. The infl ator
is not designed to operate for the
length of time necessary to infl ate
these tires.
Make sure the
universal adapter
touches the core or tire valve stem.
Open
Lock
Universal Adapter
Valve Stem
Figure 2
www.chpower.com
Operation
For use with 12-volt
DC power outlets
rated 10 amps or higher. Do not use
with older 8 amp cigarette lighter
receptacles.
Overinfl ation can be dangerous.
Pay attention while infl ating
low pressure items to prevent
overinfl ation.
TIRES
1. Remove valve stem cap.
2. Attach the universal adapter (see
Figure 2) from the inflator to the
valve stem with the lever in the up
position. Be sure to press universal
adapter down over valve stem
threads completely. When universal
adapter is firmly in place, press
locking lever down to lock onto
valve stem.
3. Plug power cord into cigarette
lighter receptacle.
4. Set automatic shut-off gauge by
turning ring on gauge until bottom
edge of pointer is just above the
desired pressure (see Figure 3).
It may be necessary
to set pointer 2-3 psi
higher than desired pressure to prevent
unit from turning off prematurely.
5. Turn on inflator and wait until
inflator shuts off.
6. Check that the tire pressure is
correct.
Figure 3 - Shut-off set for 30 psi.
2
7. To add additional air pressure, set
shut-off at higher pressure and turn
power switch off and then back on
to restart inflator.
User - Maintenance
Instructions

FUSE REPLACEMENT

NEVER replace a blown fuse with a fuse
having a higher rating.
1. Unscrew end of plug counter-
clockwise to remove fuse.
2. If fuse is blown, replace with a new
10-amp fuse. Always replace a blown
fuse with the same size fuse.
3. Reassemble plug. Do not
overtighten.

TECHNICAL SERVICE

Please call our Tool Hotline at 1-800-
543-6400 with any questions regarding
the operation or repair of this unit or
for additional copies of this manual.
UNIT REPAIR
Only qualified personnel should repair
the unit and they should use genuine
Campbell Hausfeld replacement parts
and accessories, or parts and accessories
which perform equivalently.
STORAGE
The unit should be stored in a cool dry
place.
RP3200

Publicidad

Tabla de contenido
loading

Tabla de contenido