Rack Installation; Connecting Rod; Mounting Hardware - SRAM URBAN EMATIC Manual Del Usuario

R A C K I N S T A L L A T I O N
1. If the connecting rods are not pre-assembled, use the mounting hardware to assemble the
connecting rods and bolt them into the cross brace of the rack. Use a 4 mm hex wrench to tighten the
bolts to 6-8 N m (53-70 in-lb).
•

CONNECTING ROD

VIEW FROM THE REAR
8

RACK INSTALLATION

MOUNTING HARDWARE

R A C K I N S T A L L A T I O N
1. Position the rack extensions vertically against the lower rack mounts on the frame. Install the bolt
and washer, included with your frame, through each rack extension and into the frame. Tighten to the
frame manufacturer's specifi cation.
2. Slide the rack onto the rack extensions.
3. Install the bolt and washer, included with your frame, through each rack attachment rod and into the
upper rack mounts on the frame. Tighten to the frame manufacturer's specifi cation.
4. Adjust the rack height for clearance over the brake and tire.
9
RACK INSTALLATION