Battery Installation; Connector Installation - SRAM URBAN EMATIC Manual Del Usuario

R A C K I N S T A L L A T I O N
5. Use a 4 mm hex wrench to install two bolts with washers through the rack legs and into the
extensions. Tighten the bolts to 6-8 N m (53-70 in-lb). Make sure the rack legs are set to the same
•
height on each side
6. Slide the rack along the connecting rods until the rack deck is horizontal.
7. Adjust the connecting rods on the rack cross brace so that there is an equal amount of tire clearance
on each side. Tighten the bolts to 6-8 N
•
10
RACK INSTALLATION
m (53-70 in-lb).
B A T T E R Y I N S T A L L A T I O N
1. Lift the refl ector/light mount.
2. Align the grooves in the top of the battery with the rails under the rack deck. Use the handle to push
the battery into the rack until the electrical contacts on the battery and rack securely connect.
Make sure the dock lock is in the unlocked position.
3. Lower the refl ector/light mount back down.
4. Lock the battery into the dock of the rack. Always lock the battery before riding the bike.
C O N N E C T O R I N S T A L L A T I O N
1. Align the tab on the plug with the tab on the socket. Lift the tab on the socket and insert the plug until
it snaps into place. You will hear a click when the connector is secure.
C H A R G I N G
11
LATION