Acquaer CJE075 Manual Del Usuario página 6

  5 .   U sing PVC purple primer and PVC cement, attach a 1-1/4 in.
PVC elbow (not included) onto the rigid PVC pipe extending
from the well seal.
  6 .
  N OTE: This ejector must be attached to the front of the
pump for shallow well application! Locate ejector (B) and
place gasket (AA) over venturi tube (preassembled into
the ejector (B)) so that openings in gasket (AA) match
up with openings in ejector (B). Line up the bolts (BB)
with ejector (B). DO NOT REMOVE THE VENTURI TUBE!
  H ardware Used
  7 .   S lide the bolts (BB) through the bolt openings on both
sides of the ejector (B), through the gasket (AA), and
install the assembly onto the front of the pump (A). Tighten
the bolts (BB) securely. NOTE: The 1-1/4 in. hole of the
assembly goes on top, and the 1 in. hole goes on the bottom.
  8 .   W rap thread tape around the threads of a male PVC adaptor
(not included). Thread the adaptor into the front of the
ejector (B).
  9 .   U sing PVC purple primer and PVC cement, attach as many
sections of rigid 1 in. PVC pipe and couplings (not included)
as needed to connect the 1 in. male PVC adaptor to the 1 in.
PVC elbow.
  E nsure the pipe slopes slightly toward the well (to prevent
air trapping in the pipe).
5
6
AA
BB B
7
A
B
AA
BB
8
A
B
9
B