Acquaer CJE075 Manual Del Usuario página 7

  1 0.   W rap thread tape (not included) around threads of a 1 in.
discharge tee (not included). Using a pipe wrench, thread
the 1 in. discharge tee into top of the pump.
  P roceed to the FINAL INSTALLATION INSTRUCTIONS on page 9.
DEEP WELL INSTALLATION INSTRUCTIONS
  N OTE: 1 in. and 1-1/4 in. piping must be used in this application.
WARNING! All joints and connections must be AIRTIGHT. A single leak will prevent the proper operation
of the pump. Wrap thread tape clockwise on all threaded connections. For all non-threaded connections,
you must use PVC purple primer and PVC cement to ensure airtight seals. Measure all pipe lengths
before attaching.
  W rap both ends of a 1 in. close nipple (not included) with
  1 .
thread tape (not included). Thread the 1 in. close nipple into
a 1 in. foot valve (not included). Thread the other end of close
nipple into bottom of ejector (B). Hand tighten, then tighten 1
turn with pipe wrench.
  W rap thread tape around both ends of a 1 x 5 in. nipple (not
  2 .
included), and thread the nipple into the smaller hole of the
ejector (B). Hand tighten, then tighten 1 turn with pipe wrench.
  W rap thread tape around threads of a 1-1/4 in. male PVC
  3 .
adaptor (not included), and thread over the venturi tube and
into ejector (B). Thread a 1 in. female PVC adaptor (not included)
onto the 1 x 5 in. nipple. Hand tighten, then tighten 1 turn with
pipe wrench.
10
A
B
1
B
2
B
3
B