Acquaer CJE075 Manual Del Usuario página 9

  9 .   U sing PVC purple primer and PVC cement, attach as many
sections of rigid 1 in. and 1-1/4 in. PVC pipe and couplings
(not included) as needed to connect the 1-1/4 in. male PVC
adaptor and the 1 in. female PVC adaptor to the 1 in. and
1-1/4 in. PVC elbows.
  E nsure the pipe slopes slightly toward the well (to prevent
air trapping in the pipe).
  W rap thread tape around threads of a 1 in. discharge tee
  1 0.
(not included). Using a pipe wrench, thread the 1 in.
discharge tee into top of the pump (A).
  N OTE: It is strongly recommended that a Pressure
Regulator Kit (not included) be used instead of a regular tee.
This will help to regulate fluctuations in water pressure that
can commonly be found in deep well jet pumps. Failure to
use this item may result in a loss of prime and/or irregular
water pressure.
  P roceed to the FINAL INSTALLATION INSTRUCTIONS below.
  T hese final steps are the same for both shallow well and deep well application.
  1 .   W rap thread tape around the threads of a 1 in. male PVC
adaptor (not included), and thread the adaptor into the
discharge tee (or Pressure Regulator).
  W rap all threads with thread tape. In order for the pump (A)
  2 .
and the pressure tank (not included) to operate properly, the
pressure tank needs to be drained of all water BEFORE
INSTALLING IT TO THE PUMP. Thread a 10 in. tank tee (not
included), or another necessary size tee into the diaphragm
of the pressure tank.
  P lug one outlet on top of the tank tee with a 1/4 in. plug and
install a pressure gauge (not included) on the other outlet on
top of the tank tee. Thread two 1 in. female PVC adaptors (not
included) into the two inlet sides of tank tee. Thread a 1/2 in.
relief valve (not included) and a 1/2 in. drain valve (Item not
included) to the front of the tank tee.
FINAL INSTALLATION INSTRUCTIONS
9
A
10
A
1
A
2