SPORT-ELEC SPORT PRO Manual Del Usuario página 19

STEP 2 : Starting the belt function
Once your unit is connected, install yourself comfortably and start your unit using the procedure "Starting
the unit" detailed previously in paragraph II.
STEP 3 : Stopping the belt function
Once the program is completed, disconnect the unit from the (CEV4 or CEV8) connector, and the latter from
the belt.
Remove the excess cream on the built-in electrodes using a wipe dampened with water, then dry them.
IV. Recommendation of use
The unit is recommended for physiotherapists for functional re-education.
WARNINGS :
Do not use the device by driving or by working on a machine.
Do not use this electro stimulation unit in a damp environment, a bathroom, a sauna, or
close to electric machinery connected to mains and earthed, or even piping earthed.
The simultaneous connection of a patient to a high frequency surgical unit may cause
burns at the points of contact of the stimulator's electrodes, and the stimulator may
be damaged. Operation in close proximity of a short wave therapy unit may cause
instability in the stimulator's output power.
RECOMMENDATIONS :
Please apply regulations enforced in your country
when disposing your product at its end of life.
Therefore, please discard it in a location planned to this effect,
ensuring it is disposed in an environment-friendly manner
RECOMMENDATIONS OF USE
- You can restart a program's cycle on another muscle zone or change the program while remaining on the same muscle zone, without exceeding
however 40 min use per muscle zone and per day.
- For optimum use, refer to the diagrams shown in this leaflet.
- Clean the unit and its cables with a cloth dampened with a disinfecting solution (mercryl type) diluted in water at 1/10th.
- The adhesive electrodes can be rehydrated before and after use with a disinfecting agent (e.g. hexamedine).
- The adhesive electrodes must be repositioned on their support, and stored in a fresh storage between +5°C and +10°C.
- The adhesive electrodes have a lifetime of about 40 uses, you can order them directly from the company headquarters or from your reseller.
SPORT-ELEC S.A, BP 35 Route de Rouen - 27520 BOURGTHEROULDE - FRANCE -
RECOMMENDATIONS FOR MAINTAINING AND CLEANING
THE BELT.
- CAUTION : NEVER wash in machine and under running water.
- Do not dry-clean
- Do not expose to bleach
- Clean the belt using a cloth dampened with a detergent, then wipe with a dry cloth.
- Clean the unit with a tissue dampened with a disinfecting solution (Mercryl type) diluted with water
at 1/10th.
- Clean the electrodes with a mix of water/hypoallergenic detergent, then rinse thoroughly.
PRECAUTIONS OF USE
* Do not use the unit on your face
* Do not leave within reach of children
* Ask for advice from your physician :
- if you have electronic or metallic implants (pins, etc.)
- in case of skin condition (wounds,...)
CONTRAINDICATIONS
Do not use the SPORT-ELEC
* Close to the heart
* If you carry a pacemaker
* If you are pregnant
P
C1
- 25 -
unit :
®
00.33.2.32.96.50.50
www.sport-elec.com
SAFETY CHECK
Every 24 months, check the following points :
1 - Check for superficial degradation of the equipment
2 - Check proper operation of the unit :
* legible display
* switch, contact
3 - Measure electric values :
* with a 500-ohm load, the current must not exceed 100 V.
4 - Check reliability of accessories :
* adhesive electrodes in good condition (no tears,
no material defects)
* wire of adhesive electrodes in good condition.