Removing The Attachment From The Upper Shaft; Attaching The Front Handle - Toro 51948 Serie Manual Del Usuario

4. Push in the button located on the attachment shaft. Align
the button with the guide recess on the power head cou-
pler and slide the two shafts together. Rotate the attach-
ment shaft until the button locks into the positioning hole.
Note: If the button does not release completely in the
positioning hole, the shafts are not locked into place.
Slightly rotate from side to side until the button is locked
into place.
5. Tighten the knob securely by turning it clockwise.
Coupler
Guide
Recess
Button
Attachment
Shaft
Removing the Attachment from the
Upper Shaft
See Figure 2.
Follow these steps to remove the attachment from the upper
shaft.
1. Stop the engine and disconnect the spark plug wire.
2. Loosen the knob by turning it counterclockwise.
3. Push the button while pulling out the attachment.
Assembly

Attaching the Front Handle

See Figure 3.
Follow these steps to attach the front handle.
1. Press the front handle onto the top of the upper shaft, in
2. Place the front handle along the upper shaft to a position
3. Insert the handle support tab into the slot in the front
Power
Head Shaft
4. Align the hole in the front handle with the hole in the
5. Insert bolt through holes in front handle and handle sup-
Note: Do not cover any portion of the warning label with
the front handle.
Knob
Figure 2
Tab
the position indicated by the arrow on the shaft, angling
the handle toward the throttle trigger.
that allows for comfortable operation.
handle.
handle support.
port. Secure handle in place using wing nut.
Bolt
Slot
Front
Handle
Throttle
Trigger
Handle
Support
Wing
nut
Figure 3
11