Assembly; Connecting The Attachment To The Upper Shaft; Removing The Attachment From The Upper Shaft; Attaching The Front Handle - Toro 51930 Manual Del Operador

Assembly

Connecting the Attachment to the Upper
Shaft
See Figure 2.
Follow these steps to connect the attachment to the
upper shaft.
Loosen the knob by turning it counterclockwise.
1.
Remove the end cap from the attachment shaft.
2.
Align the button on the attachment shaft with the
3.
guide recess on the upper shaft.
Slide the attachment shaft into the upper shaft until
4.
the attachment shaft clicks into place.
Note: You may need to turn the attachment shaft to
properly align the two shafts.
Tighten the knob securely by turning it clockwise.
5.
Guide
Recess
Button
Attachment
Shaft
Removing the Attachment from the Upper
Shaft
See Figure 2.
Follow these steps to remove the attachment from the
upper shaft.
Loosen the knob by turning it counterclockwise.
1.
Push the button while pulling out the attachment.
2.

Attaching the Front Handle

See Figure 3.
Follow these steps to attach the front handle.
Remove the slotted Torx™ screws to separate the
1.
handle from the handle support.
Press the handle onto the top of the upper shaft, no
2.
less than 10 in. (25.4 cm) from the center of the trig-
ger handle, angling the handle toward the trigger
handle.
12
Upper Shaft
Knob
Figure 2
Place the handle along the upper shaft to a position
3.
that allows for comfortable operation.
Place the handle support on the bottom of the tube
4.
on the opposite side of the front handle.
Secure the handle with the slotted Torx™ screws.
5.
Slotted
Torx Handle
Screw
Handle
Support

Attaching the Shoulder Strap

Model Nos. 51934 & 51940
See Figure 4.
Follow these steps to attach the shoulder strap.
Connect the latch on the strap to the hanger bracket.
1.
Adjust the strap to a comfortable position.
2.
Note: To quickly release the product from the shoul-
der strap, sharply pull the quick release tab.
Strap
Latch
.
Front
Trigger
Handle
Barrier
Bar
(Model Nos.
51934 &
51940)
Figure 3
Quick
Release
Tab
Hanger
Bracket
Figure 4
Assembly