Lift-Off Oven Door; Probe - GE CAFE 30 Manual Del Propietário

Lift-off Oven Door

The door is very heavy. Be careful when removing and lifting the door.
Do not lift the door by the handle.
To remove the door:
1. Fully open the door.
2. Pull the hinge locks down toward the door frame, to
the unlocked position. A tool, such as a small flat-
blade screwdriver, may be required.
3. Firmly grasp both sides of the door at the top.
4. Close door to the door removal position,
(approximately 15 degrees from closed) and lift it up
and out until the hinge arm is clear of the slot.
To replace the door:
1. Firmly grasp both sides of the door at the top.
2. With the door at the same angle as the removal
position, seat the indentation of the hinge arm into the
bottom edge of the hinge slot. The notch in the hinge
arm must be fully seated into the bottom of the slot.
3. Fully open the door. If the door will not fully open, the
indentation is not seated correctly in the bottom edge
of the slot.
4. Push the hinge locks up against the front frame of the
oven cavity, to the locked position.
5. Close the oven door.

Probe

Allow the temperature probe to cool before cleaning.
The probe should be cleaned with soap and water by
hand.
Do not immerse the temperature probe in water.
Do not store the temperature probe in the oven.
Do not clean the temperature probe in the self-cleaning
oven.
28
Slot
Hinge lock
Pull hinge locks down to unlock
Removal
position
Replacement
position
Bottom
Hinge arm
edge
of slot
Indentation
Hinge
arm
Hinge
lock
Push hinge locks up to lock
49-85244