Oven Racks - GE CAFE 30 Manual Del Propietário

Oven Racks

The racks may remain in the oven during the self-
cleaning cycle without being damaged.
Periodically, after several self-clean cycles, the oven
racks may need to be lubricated using the Graphite
Lubrication shipped with your range. To order additional
Graphite Lubrication, call our National Parts Center at
800.626.2002 and reference WB02T10303.
1. Remove rack from the oven. See the Full extension
oven racks section.
2. Fully extend the rack on a table or countertop.
Newspaper may be placed underneath the rack for
easy cleanup.
3. If there is debris in the slide tracks, wipe it away using
a paper towel. NOTE: Any graphite lubricant wiped
away must be replaced.
4. Shake the graphite lubricant before opening it. Starting
with left slide mechanism of the rack, place four (4)
small drops of lubricant on the two (2) bottom tracks of
the slide close to the bearing carriers.
49-85244
Right side
5. Repeat for the right slide mechanism of the rack.
Rack right-side-up
6. Open and close the rack several times to distribute the
lubricant.
7. Replace the cap on the lubricant and shake it again.
Turn the rack over and repeat steps 3, 4, 5 and 6.
8. Close the rack, turn rack right-side-up and place in the
oven. See the Full extension oven racks section.
9. Repeat above steps for each rack.
NOTE: Do not use a cooking spray or other lubricant
sprays on the slides.
Rack right-
side-up
Left side
27