Installation Procedure; Attach Brackets To The Cooktop; Install The Cooktop - Thermador SGS Serie Instrucciones De Instalación

Ocultar thumbs Ver también para SGS Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation
Procedure
Seal the Cooktop with
Foam Tape
Prepare the Countertop
Attach Brackets to the
Cooktop

Install the Cooktop

English 6
WARNING:
cooktop, switch power off at the service panel and lock the panel to
prevent the power from being switched on accidentally.
Apply the foam tape packaged with the cooktop to underside of the cooktop along
the perimeter before installing. See Fig. 3.
Cut out the countertop per the dimensions shown in section Countertop Require-
ments above.
For solid surface material installations such as Surell™ and Corian®, consult with
solid surface manufacturer. Apply heat reflective tape such as Scotch Aluminum
Foil Tape #425 or #427 around the cutout so that it folds over on the top and
sides. Do not wrap the tape underneath the cooktop. Be sure the tape extends
beyond the outermost flange of the cooktop. All corners should be covered with
tape.
Attach clamps of the hold-down brackets packaged with the cooktop to the rough-
in box. Use the washer and screws provided.
Insert cooktop into the cutout. Adjust hold-down brackets to desired position and
tighten screws to rough-in box. Insert adjusting screw into clamp and secure cook-
top to countertop.
To avoid electrical shock hazard, before installing the
Cutout shows location
of Aluminum Reflective Tape
Heat Reflective Tape
Figure 3: Counter Cutout – Solid Surface Countertops
Rough-in Box
Foam
Tape
Wooden Block
(Seal)
(to be used with
solid surfacing
material, i.e.
Clamp
Surell™ and
Corian®)
Adjusting
Screw
Adjusting
Screw
Figure 4: Attaching Hold-Down Brackets
Section "A - A"
Clamp

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Sgsx serie

Tabla de contenido