Assembly Procedure; Assembly - Marshalltown PL11 Manual Del Usuario

The MARSHALLTOWN Drywall Lift allows one person to lift a drywall panel that is up to 4ft x 16ft in size,
without assistance. The panel can be raised to a maximum height of 11ft for attachment to level ceilings-
or (with the lift's cradle tilted) to sloped ceilings or side walls.
The lift's cradle lowers to 34 inches off the floor for easy panel loading, and can support up to 150 lbs.
These instructions explain how to assemble the Drywall Lift, operate it, disassemble it after use for easy
transport and storage.
COMPONENTS
The Drywall Lift is shipped as several components
that must be assembled before use:
A. Tripod base assembly
B. Frame assembly, which includes a winch
assembly and standard (4-ft) telescoping
lift sections
C. Cradle assembly, without its detachable
crossarms
D. Two cradle crossarm assemblies

ASSEMBLY PROCEDURE

1. Set up the tripod base:
• Set the base on the floor, resting on its casters.
• Press down on the slide yoke ring. Hold the ring down
while you swing the two forward legs out until the yoke
rings snaps into the locking hole on the bottom of the
slide tube (Figure 1).
• To help keep the tripod base from rolling backward
during assembly, lower the backstop as shown in
Figure 2.
WS2091
Phone 800-888-0127 / 641-753-0127 • Fax 800-477-6341 / 641-753-6341 • www.MARSHALLTOWN.com
INTRODUCTION

ASSEMBLY

Figure 1
A
C
D
Figure 2
B
3 of 12