Operator Controls - Marshalltown PL11 Manual Del Usuario

SLIDE YOKE RING
(Figure 9)
Press down on the slide yoke ring to unlatch the
two front legs so they can be rotated out to the lift's
working position or in its storage position. A spring-
loaded pin snaps into a hole on the bottom of the slide
tube, to lock the folding legs in position.
BACKSTOP
(Figure 10)
Pivot the backstop down to help keep the base from
rolling backward. Pivot the backstop up to allow the
unit to wheel freely.
*Lock caster wheels for additional stability
PANEL SUPPORT HOOKS
Open the support hook on each crossarm to support
the drywall panel when it is being loaded, or when the
cradle is tilted.
To avoid damaging them, always close the support
hooks before transporting or storing the lift.
TILT LATCH
(Figure 12)
To allow the cradle to tilt (for loading a drywall panel,
or for raising the panel to a side wall or sloped ceiling)
pivot the tilt latch out and down. To prevent cradle tilt,
pivot the latch up to engage the stud on the cradle.
NOTE: When the cradle is in the level (non-tilted)
position, it will also tilt up to 10° side-to-side.
6 of 12
Phone 800-888-0127 / 641-753-0127 • Fax 800-477-6341 / 641-753-6341 • www.MARSHALLTOWN.com

OPERATOR CONTROLS

(Figure 11)
Figure 9
Figure 10
Figure 11
Figure 12
WS2091