Rampage 68035 Instrucciones De Instalación página 2

Installation
NOTE: Actual application may vary slightly from illustrations.
1
Remove existing soft top or hard top.
NOTE: The Rampage Complete Top for 1976-1995 Jeep CJ7 and Wrangler YJs can only
be installed on vehicles with full steel doors.
2
Position Windshield Channel onto vehicle as
shown in Figure 1.
Once in position, secure Windshield Channel
using the included (11) - #8 x ¼" Sheet Metal
Screws.
NOTE: In some cases the holes on the
Windshield Channel will line up with existing
holes. In this case, ensure holes are not too
large to install the new screws included in the
package. If holes are to big, you must replace
the included screws with larger screws, found at
any local hardware store.
If you are replacing a hardtop, use the
Windshield Channel as a template to drill 1/8"
holes.
3
Locate Passenger Side Belt Rail, (4) – 5/16" Torx
Bolts, (4) – 5/16" Flat Washers, and (4) – 5/16"
Tapping Plates.
Position Side Belt Rail onto vehicle and secure it
using the hardware listed in this step. The sheet-
metal has pre-drilled holes from the factory that
will line up with Belt Rail. See Figure 2, 3 and 4
Repeat this step for opposite side.
Figure 3
Belt Rail
Side Belt Rail Detail
Cross Section
5/16" Torx Head
Bolt and Washer
Tapping
Plate
Inside of
Vehicle
Body Panel
Figure 1
Figure 2
Belt Rail
Tapping Plate
Figure 4
Page 2 of 9
5/16" Torx
Head Bolt
5/16" Washer
Vehicle Body
5/16" Torx
Head Bolts
with Washers
Front
Side Belt
Rail