Rampage 68035 Instrucciones De Instalación página 3

Installation
4
Locate Passenger Corner Belt Rail, (2) – 5/16"
Torx Screws, (2) – 5/16" Flat Washers, and (2) –
Tapping Plates.
Position Corner Belt Rail onto vehicle and secure
it by using hardware listed in this step.
Note: There may be a slight gap between the
Corner and Side Belt Rail.
This is Normal.
See Figure 5
Repeat this step for opposite side.
5
Locate Passenger Tailgate Bracket, (2) - #10-24 x
1/2" Phillips Machine Screws, (2) - #10 star lock
washers, (2) - #10 Flat Washers and (2) - #10-
24 Nylock Nuts. In some cases the holes on the
Tailgate Bracket will line up with existing holes. In
this case, use the existing holes as pilots to drill
3/16" holes on the vehicle.
Note: Carefully check under the drilling area to be
sure you do not drill into any concealed wiring.
Note: If you are replacing a hardtop, use the
Tailgate Bracket as a template to drill 3/16" holes.
Position Tailgate Bracket and secure it by using
the hardware listed in this step
See Figure 6
Repeat this step for opposite side.
6
Lay Bow Assembly on a flat clean surface and
identify the Front and Rear Bow.
Note: The Front Bow will include foam padding
where as the rear will not.
Assemble the two halves of the Bow Assembly
using the included Connection Tubes with push
buttons. See Figure 7
Note: It may be helpful to use a flat screwdriver
to push down the buttons while sliding Bow
halves together. Also, it may be helpful for two
persons to slide both sides of the Bow Assem-
bly forward simultaneously.
Figure 5
Figure 6
Figure 7
Connection Tubes
Page 3 of 9
5/16" Torx
Head Bolts
with Washers
Rear Corner
Belt Rail
Bow Assembly