Connect Ductwork - Broan Elite RMP1 Serie Manual Del Usuario

CONNECT DUCTWORK

Ducted configuration
1. Take the discharge collar and assemble
it onto the hood's discharge opening,
pressing slightly.
2. Use 6" round metal duct to connect the
discharge collar on the hood to the
ductwork above.
3. Use duct tape to make all joints secure
and air tight.
Non-ducted recirculation configuration
1. Connect a 6" round metal duct to the
discharge opening so that the air is sent
outside the cabinet and sent back into the
room.
2. Use duct tape to make all joints secure
and air tight.
NON-DUCTED RECIRCULATION
FILTER INSTALLATION
1. Position the filters over the blower.
2. Rotate to lock filters in place.
3. Purchase replacement filter packs
(contains 2) from your dealer.
Part No. B03300487.
DUCTED CONFIGURATION
DISCHARGE
OPENING
NON-DUCTED RECIRCULATION
CONFIGURATION
DISCHARGE
OPENING
RECIRCULATION FILTERS
- 6 -
6" ROUND
METAL DUCT
DISCHARGE
COLLAR
6" ROUND
METAL DUCT
NON-DUCTED