Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
For ADA compliance installation guidelines, please visit www.broan.com
Recommended Tools and Accessories
for Installation
•
Measuring tape
•
Phillips screwdriver no. 2
•
Flat blade screwdriver (to open knockout holes)
•
Drill, 1/8" drill bit and 1½" hole saw (to mark holes for ducting and cut electrical access hole)
•
7/64" drill bit (to drill holes for EZ1 brackets mounting screws)
•
Saw (to cut holes for ducted application)
•
Wood shims (2) and wood screws (4) (required for installation to framed cabinet)
•
Sheet metal shears (ducted installation only, for duct adjustment)
•
Pliers (ducted installation only, for duct adjustment)
•
Metal foil duct tape (for ducted applications)
•
Scissors (to cut metal foil duct tape)
•
Pencil
•
Wire stripper
•
Strain relief, 1/2" diameter (to secure house wiring cable to the hood)
Install Ductwork (Ducted Installations Only)
S
C
ABINET
18"
MIN
ABOVE COOKING SURFACE
NOTE: Distances over 24" are at the installer and user discretion.
1 ] Determine whether hood will discharge vertically (3¼" x 10" or 7" round),
or horizontally (3¼" x 10" only).
2 ] Decide where the ductwork will run between the hood and the outdoors.
3 ] Choose a straight, short duct run to allow the hood to perform most efficiently. Long duct
runs, elbows and transitions will reduce the performance of the hood. Use as few of them as
possible. When possible, use at least 2 foot straight runs before any turns. Larger ductwork
may be required for best performance with longer duct runs.
4 ] Install wall cap or roof cap (sold separately). Connect metal ductwork to cap and work back
towards the hood location. Use 2" metal foil duct tape to seal the joints between ductwork
sections.
R
OOF CAP
OFFIT
H
OOD
- 24"
MAX
3¼"
10"
X
OR
7"
ROUND DUCT
(F
OR VERTICAL
)
DISCHARGE
H
OUSE WIRING
(T
)
OP OR BACK OF HOOD
W
ALL CAP
3¼"
10"
X
DUCT
(F
OR HORIZONTAL DISCHARGE
)
7
Publicidad
Capítulos
Tabla de contenido
