Mopar ADDENDUM K6861439 Manual Del Usuario página 16

20. Remove the three screws (3) that secure the clock (1)
to the back of the center bezel.
21. Remove the clock from the center bezel.
22. Obtain the new instrument center bezel included with
the kit and place it on a flat bench.
23. Position the clock (1) to the back of the instrument
panel center bezel.
24. Install and tighten the three screws (3) that secure the
clock to the center bezel.
NOTE: Make sure that the air outlets are properly
aligned to the ducts within the instrument panel
and that the foam seals on the outlets are properly
installed.
25. Position both air outlets (1) to the new instrument
panel center bezel (2).
26. Engage the six retaining tabs (3 and 4) that secure
each air outlet to the center bezel. Make sure the re­
taining tabs are fully engaged.
27. Position the center bezel near the instrument panel.
28. Connect the harness connectors (2, 3 & 4) from the
rear of the display screen (1).
29. Connect the clock harness and align the center trim
bezel to the instrument panel.
Jan 02, 2012
15
K6861439