Getting Started; S Tarting The Program - SPORT-ELEC ULTRANOMADE Modo De Empleo

I. USING THE DEVICE WITH THE ELECTRODE
This function allows you to use the adhesive electrode by connecting it directly to the unit.
G etting started
1
Remove the plastic backing sheet from the electrode.
f f
Moisten it by spreading a few drops of water onto the adhesive gel using your fingertips and wait 2 minutes.
f f
P ositioning of the electrode
2
Position the electrode on your body (cf. positions shown for guidance only).
f f
Fix the electrode to the unit using the snap fasteners taking care to place the belt (chapter II).
f f
Note: The electrode are for personal use. For hygiene reasons, they must always be used by the same person.

S tarting the program

3
Start your device by following the "Starting the device" procedure (chapter III).
Contractions should be firm but must never cause any pain.
If the electrode cause you any discomfort: reduce the power level, move the electrode and then gradually increase the
power. Also ensure that the electrode are sufficiently moistened.
Now that the settings have been optimized, let your device get to work for the full duration of the program.
E nd of program
4
Once the program finished, switch off the device by pressing the " " button, then disconnect the unit.
f f
Remove the belt.
f f
Gently remove the electrode from your skin.
f f
Moisten it slightly with a few drops of water and replace it carefully onto its transparent plastic backing sheet.
f f
Keep the adhesive electrode in a plastic bag in a cool place (for example, a separate compartment in your fridge).
II. USING THE DEVICE WITH THE BELT
The UltraNomade belt has 2 locations where the wireless electrode specially designed by SPORT-ELEC® is clipped.
Warning! Only use electrodes supplied by SPORT-ELEC®.
To obtain new electrodes, contact your usual retailer or order them from our website www.sport-elec.com.
C onnection and positioning of the belt
1
Check that your device is switched off.
f f
Open out the belt.
f f
On the back side of the belt, place the electrode with snaps across the belt holes.
f f
On the front side, place the UltraNomade device and connect it to electrode trough the belt thanks to the snaps.
f f
Place the belt around the waist and adjust it using the Velcro strip, so that there is a good contact between the
f f
electrodes and the skin.
If you experience any tingling, switch off the device and check that the electrode is in contact with the skin. If the
problem persists, contact the after-sales service: sav@sport-elec.com
- USER MANUAL
11