SPORT-ELEC ULTRANOMADE Modo De Empleo página 52

The Ultra Nomade is intended for use in the electromagnetic environment specified below. The customer or the user of
IMMUNITY IEC 60601
TEST TEST LEVEL
3 Vrms
Conducted RF
IEC 61000-4-6
150 kHz to 80 MHz
3 V/m
Radiated RF
IEC 61000-4-3
80 MHz to 2.5 GHz
Electromagnetic propagation is affected by absorption and reflection from structures, objects and people.
a. Field strengths from fixed transmitters, such as base stations for radio (cellular/cordless) telephones and land mobile radios, amateur radio, AM
and FM radio broadcast and TV broadcast cannot be predicted theoretically with accuracy. To assess the electromagnetic environment due to fixed
RF transmitters, an electromagnetic site survey should be considered. If the measured field strength in the location in which the Ultra Nomade is used
exceeds the applicable RF compliance level above, the Ultra Nomade should be observed to verify normal operation. If abnormal performance is observed,
additional measures may be necessary, such as re-orienting or relocating the Ultra Nomade.
b. Over the frequency range 150 kHz to 80 MHz, field strengths should be less than 3 V/m.
The Ultra Nomade is intended for use in the electromagnetic environment specified below. The customer or the user of
EMISSIONS TEST
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations/ flicker
emissions
IEC 61000-3-3
52
GUIDANCE AND MANUFACTURER'S DECLARATION
ELECTROMAGNETIC IMMUNITY
the Ultra Nomade should assure that it is used in such an environment.
COMPLIANCE
LEVEL
Not applicable
3 V/m
NOTE 1 At 80 MHz and 800 MHz, the higher frequency range applies.
NOTE 2 These guidelines may not apply in all situations.
GUIDANCE AND MANUFACTURER'S DECLARATION
ELECTROMAGNETIC EMISSIONS
the Ultra Nomade should assure that it is used in such an environment.
COMPLIANCE
The Ultra Nomade uses RF energy only for its internal function. Therefore, its RF
Group 1
Class B
The Ultra Nomade is suitable for use in all establishments, including domestic
Not applicable
establishments and those directly connected to the public low-voltage power
Not applicable
- EMC INFORMATION
ELECTROMAGNETIC ENVIRONMENT – GUIDANCE
Portable and mobile RF communications equipment should be used no closer
to any part of the Ultra Nomade, including cables, than the recommended
separation distance calculated from the equation applicable to the frequency
Recommended separation distance
d = 1.2
d = 2.3
where P is the maximum output power rating of the transmitter in watts
(W) according to the transmitter manufacturer and d is the recommended
separation Distance in metres (m).
Field strengths from fixed RF transmitters, as determined by an
electromagnetic site survey,a should be less than the compliance level in each
Interference may occur in the vicinity of equipment marked with
ELECTROMAGNETIC ENVIRONMENT - GUIDANCE
emissions are very low and are not likely to cause any interference in nearby
electronic equipment.
supply network that supplies buildings used for domestic purposes.
of the transmitter.
d = 1.2
80 MHz to 800 MHz
80 MHz to 2.5 GHz
frequency range.b
the following symbol: