Parts List; Date Of Manufacture - Evenflo Easy Walk-Thru Manual Del Usuario

To prevent serious injury or death, securely install gate and use according to manufacturer's instructions and warnings.
• NEVER use with a child or pet able to climb over, dislodge or open the gate.
• NEVER leave child unattended.
• NEVER use to keep child away from pool.
• To prevent falls, NEVER use at the top of the stairs.
• Intended for use ONLY with children 6 months through 24 months.
• To ensure proper fit, use ONLY in openings between 29" (74 cm) and 39" (99 cm) wide.
• Gate is not suitable for openings between 33" (84 cm) and 35" (89 cm).
• To help prevent entrapment, DO NOT allow space between bottom of gate and floor.
• Use ONLY with locking/latching mechanism securely engaged.
• To help prevent gate from dislodging, make sure all four end caps fit securely against wall or doorway opening.
• To prevent falls, DO NOT attempt to step over gate.
• STOP using gate if any parts are missing or become damaged to help ensure proper gate function.
• Use in doorways with wooden frames. When installing against drywall, ensure mounting surface is reinforced with a wall stud to
help prevent damage.
• Periodically check all fasteners to be sure they are tight and secure to prevent gate from dislodging.
• Pressure-mounted gates may dislodge if significant pressure is placed against them. Avoid applying significant pressure or weight.
• This gate will NOT necessarily prevent all accidents.
• For indoor use ONLY.
• STRANGULATION HAZARD – Pets can force themselves into very small openings. Use this gate only with pets whose head or body
WILL NOT fit into openings in the gate, between the gate and the floor, or between the gate and the wall.
• Ensure gaps between the safety gate and the side of the door frame are approximately equal.
• Ensure child is kept away from the gate when closing or opening it to prevent injury to the child, such as from pinching.
Important Information
IMPORTANT: Failure to follow installation instructions could result in serious injury to your child. Read these instructions
completely and keep for future reference.

Parts List

If you are missing parts, visit us at www.evenflo.com or call ParentLink at 1-800-233-5921.
Extension
Metal Pressure Gate
For openings 29" (74 cm) to 33" (84 cm)
Registration Information
Please register this product so we can reach you if there is a safety alert or recall. We will not sell, rent, or share your personal
information. To register your product, please complete and mail the card that came with it or visit our on-line registration at
http://plweb.evenflo.com/productreg.aspx.
For future reference, record the Model Number and Date of Manufacture below.
Model Number:
www.evenflo.com • USA: 1-800-233-5921, 8 AM – 5 PM EST
• Canada: 1-937-773-3971 • México: 01-800-706-12-00
WARNING
Adjustment Bumper (4)
Metal Pressure Gate with Extension
For openings 35" (89 cm) to 39" (99 cm)

Date of Manufacture:

Cardboard Cover
A 1. Measure and record the width of the opening where you will use
B
the gate.
2. If the opening width is 35" – 39" (89 – 99 cm), install extension
on the gate frame
extension
touch each other to securely install the extension.
NOTE: Extension can be installed on either side of gate.
B
A
B
C
3. Push four adjustment bumpers
or the gate extension.
NOTE: Make sure the adjustment bumpers are pushed all the way in.
D
B
D 4. Position gate
up and down (90º to the floor).
NOTE: Rubber contact pads may mark some mounting surfaces.
E E
Assemble Gate
WARNING
DO NOT remove cardboard cover
(or plastic tie beneath it) at this time or serious
injury may result.
B , as shown. Make sure the plastic caps on the
A and the gate B touch each other. The plastic caps MUST
C onto the corners of the gate frame
on floor in center of opening, making sure that it is straight
B
1
A
B