Publicidad
Step 6
Fasten nine ANGLE BRACKETS (L) to the UPPER ENDS (AA) and
å
FIXED SHELF (BB). Use nine BLACK 9/16" LARGE
HEAD SCREWS (W).
NOTE: Be sure the edges of the ANGLE BRACKETS are even with
å
the edges of the UPPER ENDS and FIXED SHELF.
Fasten the SHELF MOLDING (H) to the FIXED SHELF (BB). Use
å
three BLACK 9/16" LARGE HEAD SCREWS (W) through the
ANGLE BRACKETS and into the SHELF MOLDING.
Fasten the END MOLDINGS (F) to the UPPER ENDS (AA). Use six
å
BLACK 9/16" LARGE HEAD SCREWS (W) through the ANGLE
BRACKETS and into the grooves in the END MOLDINGS.
NOTE: The END MOLDINGS should rest against the
å
SHELF MOLDING.
Curved edge
Groove
Page 10
IMPORTANT
The END MOLDINGS (F) are off set 1/4" in
from the edges of the UPPER ENDS (AA).
H
BB
102792
BLACK 9/16" LARGE HEAD SCREW
L
F
AA
These edges
should be even.
W
(18 used in this step)
(9 used)
L
L
F
AA
Curved edge
Groove
www.sauder.com/services
Publicidad
