Publicidad
Step 10
Carefully stand your unit upright.
å
Fasten the DOORS (E) to the LOWER ENDS (A2). Use eight
å
GOLD 9/16" LARGE HEAD SCREWS (X).
NOTE: To adjust the DOORS up or down, loosen the screws
å
that fasten the HINGES to the unit. To adjust the DOORS side
to side, loosen the SCREWS that fasten the HINGES to the
DOORS. Tighten all screws after the adjustments are made.
Fasten the BACKPLATES (N2) and PULLS (O2) to the front
å
surface of each DOOR (E). Use a BLACK 1-1/8" MACHINE
SCREW (V) through the hole in each DOOR, through the
BACKPLATE, and into the PULL.
NOTE: Be sure the posts on the back of the BACKPLATES
å
insert into the small holes in the front surfaces of the DOORS.
The small hole will be below the large hole on the right DOOR
and above the large hole on the left DOOR.
GOLD 9/16" LARGE HEAD SCREW
(8 used for the HINGES)
BLACK 1-1/8" MACHINE SCREW
(2 used for the BACKPLATES and PULLS)
Page 14
X
The post on the
BACKPLATE
inserts into the
upper hole.
O2
V
A2
E
N2
The post on the
BACKPLATE
inserts into the
lower hole.
102792
Pro Tip: Lift with your
legs. And, you know,
your arms.
A2
E
O2
N2
www.sauder.com/services
Publicidad
