Cleaning Under The Machine; Folding The Handle; Storing The Machine In The Vertical-Stow Position - Toro Recycler 20367 Manual De Instrucciones

Indicator Indicates
light
Off No battery pack inserted
Green Battery pack is charging
blinking
Green Battery pack is charged
Red Battery pack and/or battery charger is over or under
the appropriate temperature range
Red Battery pack charging fault*
blinking
*Refer to Troubleshooting (page 18)
information.

Cleaning under the Machine

Service Interval: Before each use or daily
Cleaning under the Machine
Service Interval: After each use
For best results, clean under the machine soon after
you have completed mowing.
1. Lower the machine to its lowest cutting-height
setting.
2. Move the machine onto a paved level surface.
3. With the motor running and the blade engaged,
spray a stream of water in front of the right, rear
wheel (Figure 13).
Note:
The water will splash into the path of the
blade, cleaning out the clippings.
Figure 13
4. When no more clippings come out, stop the
water and move the machine to a dry area.
5. Run the motor for a few minutes to dry the
underside of the machine.
Cleaning under the Machine in the
Vertical-Stow Position
1. Set the machine in the vertical-stow position;
refer to Storing the Machine in the Vertical-Stow
Position (page 14).
2. Wash out the clippings from under the machine.

Folding the Handle

Folding or unfolding the handle improperly
can damage the cables, causing an unsafe
operating condition.
• Do not damage the cables when folding or
• If a cable is damaged, contact an
for more
1.
2.
3.
4.
5.
6.
g002600
Storing the Machine in the
Vertical-Stow Position
You can store your machine in the vertical position to
minimize storage space.
Folding or unfolding the handle improperly
can damage the cables, causing an unsafe
operating condition.
• Do not damage the cables when folding or
• If a cable is damaged, contact an
14
WARNING
unfolding the handle.
Authorized Service Dealer.
Remove the electric-start button
Figure 14
Remove the battery from the machine.
Hold the handle while disengaging the handle
locks to avoid pinching your hands.
Disengage the handle locks until you can move
the upper handle freely.
Fold the handle forward to the fully forward
position as shown in
Important:
Route the cables to the outside
of the handle locks as you fold the handle.
To unfold the handle, refer to
Handle (page 8).
WARNING
unfolding the handle.
Authorized Service Dealer.
(Figure 14).
Figure 16.
3 Unfolding the
g296946