Climadiff AVINTAGE AV24XI Manual De Utilización página 32

NOTE: The temperature set for the LOWER ZONE must always be the same or higher than that in the
UPPER ZONE. For optimal performance, the set temperature of the two zones should differ by at least
4°C.
You can touch SET mark to set the internal temperature for each zone. The degrees indicators will appear in the display
window marked for UPPER ZONE and
When you touch the SET mark for the first time, the LED readouts will show the original temperature sets previously (the
preset temperature at the factory for UPPER ZONE is 10ºC / 50ºF and for LOWER ZONE is 16ºC / 60ºF).
Touch the SET mark once. The left LED indicator for UPPER ZONE will flash. Then touch the UP or DOWN marks to set
the desired temperature.
When you touch the SET mark again, the right LED indicator for LOWER ZONE will flash. Then proceed to touch the UP
or DOWN marks to set the desired temperature for the LOWER ZONE.
The temperature will increase 1°C or 1ºF if you touch the UP mark once, or the temperature will decrease 1°C or 1ºF if
you touch the DOWN mark once.
To view the "set" temperature in either zone at any time, touch the UP or DOWN mark, the "set" temperature will
temporarily "flash" in the LED display for 5 seconds. You can touch the SET mark to view the temperature setting from one
zone to the second zone.
MODEL 3 ZONES
POWER
To control this appliance turn on/off. To turn OFF the appliance, press the button
LIGHT
To control the inner light turn on/off.
« UP »
Used to raise (warm) the set temperature by 1°C or 1ºF.
for LOWER ZONE.
Upper control unit
Lower control unit
c
F
c
F
and hold for 5 seconds.
32