Temperature Display - Climadiff AVINTAGE AV24XI Manual De Utilización

« DOWN »
Used to lower (cool) the set temperature by 1°C or 1ºF
ºF/ºC Selector
Select the temperature display setting in Fahrenheit or Celsius degree. To change the temperature from Fahrenheit to
Celsius or from Celsius to Fahrenheit, touch and hold button the
SETTING THE TEMPERATURE CONTROL
The wine cooler has three temperature zones. The temperature of all zones can be set separately.
The temperature settings of UPPER ZONE are adjustable with the range +14°C et +22°C (+57°F et +72°F), the preset
temperature at the factory is16°C/60°F.
The temperature settings of MIDDLE ZONE are adjustable with the range 5º-11ºC/40º-52ºF. The preset temperature at the
factory is 8ºC / 46ºF.
The temperature settings of LOWER ZONE are adjustable with the range 11º-13ºC/52º-56ºF. The preset temperature at the
factory is 12ºC / 54ºF.
Temperature control for upper and middle ZONE at upper control unit. Temperature control for lower ZONE at lower control
unit.
To view the "set" temperature in either zone at any time, touch the UP or DOWN mark, the "set" temperature will
temporarily "flash" in the LED display for 5 seconds.

TEMPERATURE DISPLAY

During normal operation, the temperature display on the control panel shows the temperature inside the appliance. The
temperature display will flash if:
- A different temperature is being set,
- The temperature in the zone deviates by more than 5°C from the set temperature. The temperature display flashing
ensures that the temperature can not rise or fall un-noticed and impair the wine.
SHELVES
To prevent damaging the door gasket, make sure the door is fully open when pulling shelves out of the rail compartment.
For easy access to the bottles stored, pull the shelves out approximately 1/3. The shelves are designed with an
emergency stop to prevent them being removed too far when loaded.
for 5 seconds.
33