Usage Instructions; General Description; Preparation - ZUMEX Minex Manual De Usuario

USAGE INSTRUCTIONS

GENERAL DESCRIPTION

ZUMEX MINEX
1 Feeder door
2 Counterweight
3 Dispenser
4 Feeder Ramp
5 Retainer
6 Cover
7 Juice Container
8 Juice Container Filter
9 Drip tray
10 MX male drum
11 Blade
12 Tipping blade holder
13 MX female drum
14 Left peel ejector
15 Wheel
16 Blade lock
17 Silicone seal
18 Extra push button
19 Tap fitting and joint assembly
20 Colour Kit

PREPARATION

To start operating the juice extractor, proceed as follows:
1
Remove the appliance from its packaging and place it on a surface that is as horizontal as
possible.
2 Check that the electricity voltage is within the limits indicated on the machine characte-
ristics label which can be found on the cover of this manual and on the machine itself.
3 Place the feeder ramp on the machine as shown in Fig. 1
4 Plug the cable supplied with the machine into a standard socket with a ground connec-
tion, Fig. 2
5
Before using the machine, install the tap fitting as shown in figures 3 and 4. Remove the
jug, open the top cover and remove the juice container. The tap fitting and push button
are inside the jug. Take out both parts and install the tap. Keep the button for future use.
Replace the container, close the cover and replace the jug in the machine, in that order.
Check that the cover, juice container and peel container are properly inserted in place, as
6
otherwise the machine safety sensors will not allow it to be started.
Important: Your machine has been designed to squeeze citrus fruits with
diameters of between 65 and 78 mm. To confirm the correct size of your
orange, measure the diameter of your fruit with the caliper accessory
supplied with your machine. Discard citrus fruits that do not fit through
the 78mm circle and those that pass through the 65mm circle.
Minimum ø65mm
Maximum ø78mm
17