Warranty; Instructions For Use; Preparation - ZUMEX AUTOSERVICIO BARRA Manual De Usuario

MANUAL USUARIO Z auto-Z fresh 27/10/06 16:48 P gina 14

3. WARRANTY

• SCOPE OF THE WARRANTY: The unit has a two-year
warranty against defects and construction problems that could
harm the correct operation, provided that the inner parts or
mechanisms have not been manipulated. The following are
excluded from the warranty.
• EXCLUSIONS: Labor, trips, transport, parts that have become
deteriorated due to natural wear as a consequence of use, as
well as any damage resulting from the incorrect usage or
installation of the unit and faults caused as a result of force
majeure.
• Any incorrect handling of the ID Label will make the Warranty
void. Likewise, the warranty will also be void if other persons
handle the unit, since only the Official Technical Support Service
is qualified and authorized to do so.
• Always provide the SERIAL Nº on the ID Label when
contacting the Technical Support Service.
26

4. INSTRUCTIONS FOR USE

4.1 PREPARATION

To operate the juicer, follow these steps:
1 - Remove the packaging and place the unit on a flat surface.
2 - Use the correct voltage, as described on the ID label of the unit and on the
first page of the manual.
3 - Zumex Autoservicio Barra
• On the feeding basket of the machine you will find the following: base
supplement and stainless steel front tap. Inside the base of the machine you
will find the peel containers and glass tray with its filter.
• To install the machine, place it on the base supplement, which is required to
raise the machine and for the correct operation of the tap.
• Screw the tap, as shown in Fig. 2 (drop-down diagram) to the machine's juice
container which includes a threaded front outlet to attach the tap.
• Place the peel containers on both sides of the machine under the peels and
the glass tray with its filter under the juice outlet.
4 - Zumex Autoservicio
• When you purchase a Zumex Self-Service machine, you will receive two
packages: Open both packages, which will include the juicer and the base
stand.
• The feeder basket of the machine includes the stainless steel front tap, remove
the package and keep it for assembly at a later stage.
• After removing the packaging of the base stand, remove the screws of the
fixing bracket (drop-down diagram) and keep it for assembly at a later stage.
Inside the base of the machine you will find the peel containers and drip tray
of the base stand with its filter.
• To install these elements, block the front wheels of the base stand with the
brake pedal to avoid it from moving during the installation, details in Fig. 1
(drop-down diagram).
EN
27