Nokia 530 XpressMusic Manual Del Usuario página 77

To edit a packet data access point, open one of the access point groups, and select an
access point marked with
Follow the instructions from your service provider.
Select from the following:
● Access point name — You obtain the access point name from your service provider.
● User name — The user name may be needed to make a data connection, and is
usually provided by your service provider.
● Prompt password — If you must enter the password every time you log in to a
server, or if you do not want to save your password in the device, select Yes.
● Password — A password may be needed to make a data connection and is usually
provided by your service provider.
● Authentication — Select Secure to always send your password encrypted or
Normal to send your password encrypted when possible.
● Homepage — Depending on the access point you are setting up, enter the web
address or the address of the multimedia message center.
● Use access point — Select After confirmation if you want the device to ask for
confirmation before the connection using this access point is created, or
Automatically if you want the device to connect to the destination using this access
point automatically.
Select Options > Advanced settings and from the following:
● Network type — Select the internet protocol type to transfer data to and from your
device. The other settings depend on the selected network type.
● Phone IP address (for IPv4 only) — Enter the IP address of your device.
● DNS addresses — Enter the IP addresses of the primary and secondary DNS servers,
if required by your service provider. To obtain these addresses, contact your internet
service provider.
● Proxy server address — Enter the address of the proxy server.
● Proxy port number — Enter the port number of the proxy server.
WLAN internet access points
Select Menu > Settings and Connectivity > Destinations > Access point, and
follow the instructions on the screen.
To edit a wireless LAN (WLAN) access point, open one of the access point groups and
select an access point marked with
Follow the instructions from your WLAN service provider.
● WLAN network name — Select Enter manually or Search for networks. If you
select an existing network, WLAN network mode and WLAN security mode are
determined by the settings of its access point device.
● Network status — Define whether the network name is displayed.
● WLAN network mode — Select Ad-hoc to create an ad hoc network and to allow
devices to send and receive data directly; a WLAN access point device is not needed.
In an ad hoc network, all devices must use the same WLAN network name.
© 2009 Nokia. All rights reserved.
.
.
77