Assembly; To Assemble The Loop Handle; To Disassemble The Two-Piece Shaft; To Assemble The Two-Piece Shaft - Husqvarna 525LK Manual Del Usuario

Introduction
WARNING: Before you assemble the
product, you must read and understand the
safety chapter.
WARNING: Remove the spark plug cable
from the spark plug before you assemble the
product.

To assemble the loop handle

1. Put the loop handle onto the shaft, between the
arrows.
2. Put the spacer into the slot of the loop handle.
3. Install the nut, the knob and the screw. Do not
tighten fully.
4. Adjust the product to an applicable operation
position.
5. Tighten the knob.

To assemble the two-piece shaft

1. Turn the knob to loosen the coupling.
2. Align the tab of the cutting attachment (A) with the
arrow of the coupling (B).
B
10

Assembly

3. Carefully push the shaft into the coupling until you
4. Tighten the knob fully.

To disassemble the two-piece shaft

1. Turn the knob 3 turns or more to loosen the
2. Push and hold the button (C).
3. Hold tight in the end of the shaft that the engine is
A
hear a click.
coupling.
attached to.
1027 - 001 - 23.04.2019