Symbols On The Product - Husqvarna 525LK Manual Del Usuario

3. Bevel gear
4. Cutting attachment guard
5. Shaft
6. Loop handle
7. Throttle trigger
8. Stop switch
9. Throttle trigger lockout
10. Spark plug cap and spark plug
11. Shaft coupling
12. Cylinder cover
13. Starter rope handle
14. Fuel tank
15. Air filter cover
16. Air purge bulb
17. Choke control
18. Handle adjustment
19. Drive disc
20. Operator's manual
21. Hex key
22. Locking pin
23. Combination wrench

Symbols on the product

Be careful and use the product correctly.
This product can cause serious injury or
death to the operator or others.
Read the operator's manual carefully and
make sure that you understand the
instructions before you use this product.
Use a protective helmet in locations where
objects can fall on you. Use approved
hearing protection. Use approved eye
protection.
Use approved protective gloves.
Use heavy-duty slip-resistant boots.
The product can cause objects to eject,
which can cause injury.
Maximum speed of the output shaft.
Keep a minimum of 15 m distance to
persons and animals during operation of the
product.
1027 - 001 - 23.04.2019
Only use flexible cutting wire. Do not use
metal cutting equipment for grass trimming.
The arrows show the limit for the handle
position.
Air purge bulb.
Choke.
Fuel.
yyyywwxxxx
Note: Other symbols/decals on the product refer to
certification requirements for some markets.
EPA III
The Emissions Compliance Period referred to on the
Emission Compliance label indicates the number of
operating hours for which the engine has been shown to
meet Federal emissions requirement. Maintenance,
replacement or repair of the emission control devices
and system may be performed by any nonroad engine
repair establishment or individual.
The rating plate shows the
serial number. yyyy is the
production year, ww is the
production week.
3