Maxon 298901-01 Manual De Instrucciones página 8

CAUTION
Do not force spacers between the
stop block and runner. Spacers
should only be inserted by hand.
Only a maximum of 2 spacers (if
any) are needed.
20. Raise platform to bed height (FIG. 8-1).
Insert shims as needed (FIG. 8-1A) to
fi ll gap between stop block and runner
(2 shims maximum).
21. Lower platform until bottom of each
runner is 10" off the ground. Then,
tighten bolts on the stop block (FIGS.
8-1A and 8-1B). Torque the 5/8"-11
bolts 170 to 254 lb-ft.
FRONT VIEW OF LH RUNNER
22. Repeat steps 19 to 21 for the
RH runner. Torque the 1/2"-13
bolts 85 to 128 lb-ft.
© MAXON Lift Corp. 2017
LIFT CORPORATION Sht. 8 of 18 DSG#
BOTTOM
BOLTS
RUNNER
FIG. 8-1B
M-17-17
1/16" SPACER
1/32" SPACER
TOP
BOLTS
STOP
BLOCK
REAR VIEW OF LH RUNNER
PLATFORM RAISED
TO BED HEIGHT
STOP
FIG. 8-1
BLOCK
Rev. A Date: 12/20/17
GAP
SIDE
BRACKET
FIG. 8-1A